[GreenKeys] The J1 Wrench, etc.

[Don Robert House]

Roy,

Thanks for your support.
It is posted on George's site:  http://www.rtty.com

Don


On 3 Aug 2006, at 7:52 AM, Roy Morgan wrote:

Greenkeyers,

Most likely from one of our resource sites, I got a digital copy of:

TELETYPEWRITER MAINTENANCE TOOLS
Section 570-005-800TC
Issue  6 August 1977

in the form of the file toolbook.pdf.  It is some 2+ Mb in size.

I have emailed it to Don, and can also send it to someone who has a  
site to post it on in case it's not on RTTY.com or somewhere else.

Roy




At 09:53 PM 8/2/2006, Don Robert House wrote:
> I think I may have given out some incorrect information.
>
> The J1 wrench used to adjust many parts in a M28 typing unit,
> especially the clutches, is a small double open end wrench about 5/64
> inch thick.
>
> The small open end is 3/16 inch and the large end is 1/4 inch when
> new.  After some years of use the 1/4 inch end becomes 17/64 inch.
>
> The J1 wrench is made of stamped steel that is apparently heat
> treated.  One side is stamped J1.
>
> I think it also has a Teletype part number, but I do not have it
> here.  My tool catalog is in California.
>
> If any of you have a Teletype tool catalog, I would gladly pay for a
> copy.


- Roy Morgan, K1LKY since 1959 - Keep 'em Glowing!
NEW: 13033 Downey Mill Road
Lovettsville, VA 20180
Phone 540-822-5911
Cell 301-928-7794
Work: Voice: 301-975-3254,  Fax: 301-975-6097
roy.morgan at nist.gov --

Old address: 7130 Panorama Drive, Derwood MD 20855
Home: 301-330-8828

_______________________________________________
GreenKeys mailing list
GreenKeys at mailman.qth.net
http://mailman.qth.net/mailman/listinfo/greenkeys