[GreenKeys] Model 28 ASR

[The Rices]

The selectors are fine or it wouldn't lock up in test mode. Thanks Though

-----Original Message----- 
From: tony.podrasky 
Sent: Wednesday, June 11, 2014 12:26 PM 
To: The Rices ; GreenKeys at mailman.qth.net 
Subject: Re: [GreenKeys] Model 28 ASR 

Hey Rice-Guy;

Remember: those magnets are really low in the Ohms department,
which is why you need a current limiting resistor in series with them.

You might want to disconnect one of the leads on one of the magnets
and put the Ohm meter to it to see how it reads.

UE,
W6ESE _ TONY
NNNN
ZCZC


On 06/11/2014 09:11 AM, The Rices wrote:
> Question for the model 28 user. I am testing out my 28 ASR page printer
> and keyboard and it works fine in test mode. When I check to hook up the
> line wires to terminals 1 and 2 I get a dead short on those terminals.

-- 
I wanted to find out just how much the Earth weighs
so I went into the bathroom and turned the scale
up-side-down. BAD PLAN: the scale was crushed beyond
recognition.  I'm not strong enough to lift the
Earth off of it, so now I'm stuck with a paper-thin
scale on my bathroom floor.       - Tony J. Podrasky


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2014.0.4592 / Virus Database: 3955/7661 - Release Date: 06/11/14