[GreenKeys] KLINSCHMIT TT-117 WIRING HELP

[Al.Last at sbcglobal.net]

I have been working on my Klienschmit TT-117 tty for the past year. Special thanks to Steve N4TTY for providing me the main drive shaft WITH the gears. I could never have gotten past first base. I now have one remaining problem that some one of you might have knowledge to help me finish this project. My TT-117 is the version that came from a Crypto system.. It has the red light on the front housing; a 1" diameter 18" long cable/connector hanging from left side;  the typing 70 something levers that flip up to remember the key strokes (???); the keyboard rotating disk with a knife lever that stops the rotation once a key stroke occurs (normal knife has two ends - mine has only the start side ). Now the problem....... the unit keeps rotating. It is suppose to stop after it rotates once and wait for the next keyboard selection. There is a solenoid ???? round module directly behind the kyboard that has a flat lever which trips the run/stop on the front right. This lever appears to stop rotation waiting. The two wires from the round module runs to the horizontal sliding red arrow that runs across the faceplate. I DO NOT HAVE ANY INFORMATION on this final problem(s). I don't see any source to activate solenoid? 


Sorry for this long email, but after 1 years labor, your input could save me hours of interpurlating.

Al W6GSQ
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/greenkeys/attachments/20171203/166805bb/attachment.html>