[ICOM] IC-775 Display issue - need advice

[Anders Janis SM4RNA]

Exactley this has happend to two of my friends IC-775's. In both cases there was bad soldering. The pcb on the back of the display has much larger holes than the wires is. Re solder them and all is ok. You need to flip down the front and remove tha back cover and then you can do the soldering.

gl de Anders SM4RNA


----- Original Message ----- 
From: "Dave Meitzen" <dmeitzen at comcast.net>
To: "'ICOM Reflector'" <icom at mailman.qth.net>
Sent: Thursday, May 04, 2006 5:50 PM
Subject: [ICOM] IC-775 Display issue - need advice


> When I first turn the unit on the right side of the display (Dual Watch,
> etc.) the digits show some segments not displaying correctly. After a warm
> up period -- say 10-20 minutes the display problem disappears. How can I fix
> this?
> 
> Thanks
> Dave
> 
> ----
> Your Moderator: Dick Flanagan K7VC, icom-owner at mailman.qth.net
> Icom Users Net: Sundays, 1700Z, 14.316 MHz
> Icom FAQ: http://www.qsl.net/icom/