[Milsurplus] National R-1230 countermeasures receiver

[Francesco Ledda]

In the manual I provided you, there is the schematic of the external power supply. This provides power and synchronization to 6 receivers. You should have all you need to figure things out.

I am out of town this week, but if you need further help, I can look at my notes, when I get back home.

I have 2 r-1230 working here with an home grown dsp based IQ demodulators.

Regards,

Francesco

Sent from my iPad

On Dec 1, 2011, at 8:29 PM, HL <zbyte at comcast.net> wrote:

> 
> Peter:
> 
> Many thanks.  I have travelled down that road to some extent.  The power plug is an Amphenol 18-1 with ten pins, A through J.  "H" is probably ground. "A" and "B" are probably 115VAC. "F" and "G" are tied together and not used --unless as a bridge.  The other pins go through fuses to hidden areas in silver module boxes as seen in the photo I took of the bottom interior:
> 
> http://online.sfsu.edu/~hl/R-1230FLR.html
> 
> The receiver has 28 tubes and assorted lamps that receive ACV from four taps on the separate power transformer: 6.3V at 0.5A, 
> 18V at 4.0A, 5VAC at 5.0A, and 7.3VAC at 30.0A. Note from my photo that the tube bottoms are hidden in these modules, so if I don't find the schematic, 
> I will have to use Vector 9-pin and 7-pin tube extenders to trace the filament connections of each tube individually to determine how they are grouped.
> 
> I enjoy this kind of mystery solving, but, alas, this receiver weighs 65 pounds.
> 
> Regards, Hal KK6HY
> 
> On Dec 1, 2011, at 4:36 PM, Peter Gottlieb wrote:
> 
>> You should be able to figure out several pretty easily.  Start with ground, then use an ohmmeter to track back from a 6 volt tube to the 6.3 VAC pins, same for a 5 volt tube.  Find a plate of some output tube and that should lead you to B+ input (175 VDC?  or is there a separate supply run by 115 VAC inside?).  Either way you will know, and presumably there is some 115 VAC transformer in there from which you can ohm out those input pins.  That kind of technique should get you pretty far.
>> 
>> On 12/1/2011 6:44 PM, HL wrote:
>>> 
>>> 
>>> Wanted: manual, schematics for National Radio Company’s 1963 countermeasures receiver, Models R-1230 (aka: R-1125 or AN/FLR-11 or AN/FRA-54). (Manual ID: NAVSHIPS 94581) I think I can deal with its 65kHz IF output, and I can provide the needed power voltages, but am stymied without a schematic by the power connector with its ten unidentified pins (A through J) for 175VDC, 6.3VAC, 18VAC, 5VAC, 115VAC, etc. Would love to get this wonderfully built, complex beast operating! Any info will be appreciated. Holiday greetings, Hal KK6HY
>>> _
> 
> ______________________________________________________________
> Milsurplus mailing list
> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Milsurplus at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html