[Milsurplus] BC348 IF transformer tuning tool ?

[Mark K3MSB]

Remove the handle and nut securing the switch then move the switch back a
bit to give you some room?

Mark K3MSB

On Thu, Oct 9, 2025 at 4:42 PM jphutch60bj <jphutch60bj at gmail.com> wrote:

>
> Finished replacing Resistors that were out of spec in my second BC348-R
>
> Finished aligning the set for the most part.
>
> BC348 IF tuning tool ?  I have a Straw type tuning tool I use to adjust
> the bottom of the IF transformers.
>
> --> My issue is, it is to fat to adjust the 2nD IF, secondary coil in
> the vicinity of, under,  the power switch! (pic attached)
>
> The tuning tool I use is "standard" off the shelf tool, its basically a
> tough straw with a metal insert.
>
> Anyone have a tool that can sneak through the switch to tweak the IF
> transformer?
>
> A picture, with a description would help.
>
> I  may have to make one out of a chopstick ?
>
> Thanks
>
> JPHutch
>
> .
>
> ______________________________________________________________
> Milsurplus mailing list
> Home: http://mailman.qth.net/mailman/listinfo/milsurplus
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Milsurplus at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.qth.net/pipermail/milsurplus/attachments/20251011/959c1bf6/attachment.html>