[1000mp] FT-1000MP No power output

[Mike Schatzberg]

It would still be highly unlikely that the MP would show the SWR to be okay,
and the power output to be 100 watts, with only 20 watts or so indicated on
the outboard wattmeter.  I would get a known high quality wattmeter and good
cables to recheck if the MP shows everything is okay.

73,

Mike
W2AJI
----- Original Message ----- 
From: "Scott & Laura Goldensoph" <goldy98 at mchsi.com>
To: "All about Yaesu 1000mp" <1000mp at mailman.qth.net>
Sent: Wednesday, September 20, 2006 12:48 PM
Subject: Re: [1000mp] FT-1000MP No power output


> He has the original 100 watt version of the FT-1000MP, not the Mark V, I
am
> not sure of the diiferences between the two. I will have him check for the
> ALC line for the amp though. He said he took the tuner and the amp out of
> line and just fed from the radio into the watt meter then into the dummy
> load.
> ----- Original Message ----- 
> From: "Mike Schatzberg" <cherokeehillfarm at earthlink.net>
> To: "All about Yaesu 1000mp" <1000mp at mailman.qth.net>
> Sent: Wednesday, September 20, 2006 7:52 AM
> Subject: Re: [1000mp] FT-1000MP No power output
>
>
> > PS:
> >
> > I would also borrow  a know high quality wattmeter, to be sure of the
> > results.  The Mark V wattmeter, I have found, is very accurate indeed.
> >
> > It would be pretty rare I think, for the SWR meter in the Mark V to show
a
> > good match, and the Mark V wattmeter to show full output.
> >
> > 73,
> >
> > Mike
> > ----- Original Message ----- 
> > From: "Cecil Acuff" <chacuff at cableone.net>
> > To: "All about Yaesu 1000mp" <1000mp at mailman.qth.net>
> > Sent: Wednesday, September 20, 2006 8:30 AM
> > Subject: Re: [1000mp] FT-1000MP No power output
> >
> >
> >> Good place to start is to make sure nothing is connected to the ALC
jack
> > on
> >> the rear....like an amp that might be reducing the power.  Don't
> > understand
> >> the metering though...
> >>
> >> I think there are also some menu settings that will limit max power
> >> out...don't have my owners manual handy.  Make sure that's not the
> > problem.
> >> What does the internal metering say about reflected power into the
dummy
> >> load?  Could be an antenna tuner problem where it has failed.  I
believe
> > it
> >> is bypassed by a relay when switched off but I'd again have to look at
> >> the
> >> manual.  Should show a good match into a dummy load.
> >>
> >> Will need a manual to get into it deeper....
> >>
> >> Cecil...
> >> ----- Original Message ----- 
> >> From: "Scott & Laura Goldensoph" <goldy98 at mchsi.com>
> >> To: <1000mp at mailman.qth.net>
> >> Sent: Tuesday, September 19, 2006 9:08 PM
> >> Subject: [1000mp] FT-1000MP No power output
> >>
> >>
> >> I have a ham friend that has no internet access that also has a 1000MP.
> > The
> >> meter on the radio says it is putting out 100 watts but the Daiwa and
MFJ
> >> watt meters say otherwise. In CW keydown into a dummy load, it will put
> > out
> >> about 15-20 watts. Any ideas what went wrong with it or at least a good
> >> direction on where to start? 73's de KC0THF/AG
> >> ______________________________________________________________
> >> 1000mp mailing list
> >> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> >> Help: http://mailman.qth.net/mmfaq.html
> >> Post: mailto:1000mp at mailman.qth.net
> >>
> >>
> >> ______________________________________________________________
> >> 1000mp mailing list
> >> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> >> Help: http://mailman.qth.net/mmfaq.html
> >> Post: mailto:1000mp at mailman.qth.net
> >
> > ______________________________________________________________
> > 1000mp mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/1000mp
> > Help: http://mailman.qth.net/mmfaq.html
> > Post: mailto:1000mp at mailman.qth.net
>
> ______________________________________________________________
> 1000mp mailing list
> Home: http://mailman.qth.net/mailman/listinfo/1000mp
> Help: http://mailman.qth.net/mmfaq.html
> Post: mailto:1000mp at mailman.qth.net