[1000mp] Mark V A and B audio?

[Bill Gode, Sr.]

Connect a patch cable from the front panel headphone jack to an outboard 
2-channel amplifier driving your external speakers.  That way, the Main and Sub 
AF gain controls on the radio will independently control the volume of your twin 
speakers.

It's even easier to simply connect a pair of amplified computer speakers to the 
headphone jack of your MP and position the 2 speakers for the desired amount of 
separation.

73,

Bill, W9NHQ


----- Original Message ----- 
From: "Louis Dietrich" <n2tu at roadrunner.com>
To: "'All about Yaesu 1000mp'" <1000mp at mailman.qth.net>
Sent: Wednesday, February 20, 2008 7:13 PM
Subject: RE: [1000mp] Mark V A and B audio?


> Mike,
>
> Thanks for the response....but...I don't think my original post was
> clear....
>
> I want to drive a left speaker with VFO A and the right speaker with VFO
> B...as is done when you have a headset on....
>
> I do not want to drive two speakers with the same audio output....
>
> Thanks....
>
> 73
>
> Lou N2TU
>
> -----Original Message-----
> From: 1000mp-bounces at mailman.qth.net [mailto:1000mp-bounces at mailman.qth.net]
> On Behalf Of Mike Schatzberg
> Sent: Wednesday, February 20, 2008 7:35 PM
> To: All about Yaesu 1000mp
> Subject: Re: [1000mp] Mark V A and B audio?
>
> Hello Lou:
>
> I drive two speaker consoles in parallel with my Mark V, using both the SP
> 8, and the Kenwood SP 230.  I just use the speaker output and split it with
> a Y adapter.
>
> Currently, I run an Orion II as well, the same way, using the Ten Tec
> console and the SP 8.
>
> I like the spatial effect, with one speaker on the left and 6 inches above
> my radio, the other on the right at the same height as my radio.  I can not
> tell where the sound is originating from.
>
> I also use baffles in both speaker consoles made from foam rubber.
>
> 73 and Happy DXing,
>
> Mike
> W2AJI
> ----- Original Message ----- 
> From: "Louis Dietrich" <n2tu at roadrunner.com>
> To: "'All about Yaesu 1000mp'" <1000mp at mailman.qth.net>
> Sent: Wednesday, February 20, 2008 6:53 PM
> Subject: [1000mp] Mark V A and B audio?
>
>
>> Group,
>>
>> Has anyone successfully split the Mark V's output audio to drive two
>> separate speakers?....the rear panel "Ext Spkr" combines A & B....and the
>> "AF Out" is a fixed level output (front panel controls do not vary the
>> output)....
>>
>> Thanks....
>>
>> 73
>>
>> Lou N2TU