[GreenKeys] MODEL 28 hiccup

[Doug Alderdice]

I was going to say the same thing: it sounds like there's a stunt box 
fork set up for non-printing on the semicolon code.  Short of pulling 
the stunt box, Jim's advice is good to manually work the motor and watch 
what happens.  Leave loop on the keybd and selector magnets with the 
motor off so you can see which forks engage on what codes.

73,

Doug, KA2WFT


On 12/30/2018 3:35 PM, Jim Haynes wrote:
> Since you have a KSR, to make it easier to see what is going on with
> the stunt box you can disconnect power to the motor and turn it by hand
> while you trigger the action in question.
> 
> By sending characters like LTRS you can find the part that does spacing
> suppression.  Then you can see which stunt box slot is operating the
> same part on semicolon.
>