[GreenKeys] MODEL 28 hiccup

[Doug Alderdice]

Auugh ... I meant non-spacing, not non-printing!

On 12/30/2018 4:44 PM, Doug Alderdice wrote:
> I was going to say the same thing: it sounds like there's a stunt box 
> fork set up for non-printing on the semicolon code.  Short of pulling 
> the stunt box, Jim's advice is good to manually work the motor and watch 
> what happens.  Leave loop on the keybd and selector magnets with the 
> motor off so you can see which forks engage on what codes.
> 
> 73,
> 
> Doug, KA2WFT
> 
> 
> On 12/30/2018 3:35 PM, Jim Haynes wrote:
>> Since you have a KSR, to make it easier to see what is going on with
>> the stunt box you can disconnect power to the motor and turn it by hand
>> while you trigger the action in question.
>>
>> By sending characters like LTRS you can find the part that does spacing
>> suppression.  Then you can see which stunt box slot is operating the
>> same part on semicolon.